Bimini, Cabin Top and Cushions

Northern Cross is back from the upholstery shop.

Check it out:

OLYMPUS DIGITAL CAMERA

Cabin top in stormy weather configuration, buttoned down for the night.  The vertical bulkhead panels are velcro’ed around the edges.  

OLYMPUS DIGITAL CAMERA

The cabin top secures with snaps…

OLYMPUS DIGITAL CAMERA

wrapped down around the cabin walkway.  

OLYMPUS DIGITAL CAMERA

I wanted a longer flap than normal on the front filler board, to keep water out of the cabin when driving down the road.  

OLYMPUS DIGITAL CAMERA

Cabin entrance with rain panels removed. The bug panels also remove by unzipping from the cover at the top edge.  

OLYMPUS DIGITAL CAMERA

The bug netting snaps back out of the way for easy entrance.  

OLYMPUS DIGITAL CAMERA

Bunk cushions were made from 3″ dense foam.  They fit beautifully and still allow great access to storage below.  

Now for the Bimini:

OLYMPUS DIGITAL CAMERA

Bimini in the up position.  It rests across the hand rails of the motor cover when traveling.   I also have a travel cover that fits over everything that I’ll show in a later post.  

OLYMPUS DIGITAL CAMERA

OLYMPUS DIGITAL CAMERA

Bimini in the up position.  I held the Bimini forward in the cockpit to offer more protection when standing and motoring.  It’s about 6′ in length.  

OLYMPUS DIGITAL CAMERA

After looking things over, we decided the best place to mount the Bimini, was directly onto the oak handrails.  This widened the Bimini and kept the bars out of way of my elbows while also providing a little more shoulder room.   It should also keep a little more water out of the boat.  

OLYMPUS DIGITAL CAMERA

Stainless fittings secure the aluminum uprights.  I applied lock tight to the screws to prevent them from vibrating out when traveling.  

OLYMPUS DIGITAL CAMERA

The Bimini was secured by screwing the webbing directly to the tubing.  Though this might work fine , it didn’t seem secure enough to me.  

OLYMPUS DIGITAL CAMERA

Instead, I decided to wrap the webbing around the tubbing with simple knot.  

OLYMPUS DIGITAL CAMERA

I then replaced the screw to keep the webbing from shifting up or down the tube.  With the webbing wrapped around the tubing, it’ll be much more secure.  

OLYMPUS DIGITAL CAMERA

I used stainless pad-eyes to secure the forward webbing straps.  

OLYMPUS DIGITAL CAMERA

The aft strap was secured in a similar way.  

OLYMPUS DIGITAL CAMERA

And, there you have it.  Secure and solid.

Summary:

I’m now adding a compass to the bulkhead and a tow hook to the transom (for rescuing stranded ski boats on the reservoir).  I’m all but done folks and it feels so good.  I’m looking to get back on the water for the official launch early next month.  

Advertisements

Odds n Ends

I snuck in a few hours this morning to get a few odds n ends knocked out.

Take a look:

OLYMPUS DIGITAL CAMERA

Navigator console with 2nd coat of epoxy applied.

OLYMPUS DIGITAL CAMERA

Throttle/Shifter mount from Okoume plywood.

OLYMPUS DIGITAL CAMERA

Angled bimini mounts from mahogany.

Summary:

I’m really looking forward to building the last 2 major items for my boat.  Namely, the motor cover and the outboard ladder.  Still tons of little things to do, but definitely getting closer.